The last touch to installing a pocket door is to affix and trim the door jambs. Trimming the jambs for a pocket door is a much various process than for a continuous door. This task needs jambs on both sides of the inside pocket; and also on the door framework for a professionally finiburned appearance. Take your time and you will certainly have actually a perfectly finished pocket door.

You are watching: How to trim out a pocket door

Tip 1 - Meacertain the Pocket Side Jambs

Meacertain the elevation on both sides of the pocket side jamb. Cut a 1x4 inch board to this measurement. Use a circular saw for this cut. Now, meacertain the pocket door framework from the edge of the pocket to the edge of the wall. Generally 1x¼-inches but it is best to measure for accuracy.


Tip 2 - Cut the Pocket Side Jambs

You are going to rip or reduced lengthwise the pocket side jambs. You will need to use the rip blade with the circular experienced for this cut. You will certainly be cutting through the grain. The rip blade gives you a clean reduced and also helps prevent dividing the board.

Tip 3 - Attach the Pocket Side Jambs

Take the cut piece and line it up with the inside of the pocket door frame. Make certain it lines up flush. Secure it via screws. It is wise to drill pilot holes for the screws throughout this project, for this reason preventing dividing the hardwood.

Tip 4 - Meacertain the Header

At the top of the pocket door structure, meacertain the length on each side. Measure the width from the wall to the edge of the pocket door frame.

Step 5 - Cut the Header

Cut a 1x4 inch board then rip to the dimensions through the circular witnessed and also rip blade.

Step 6 - Attach the Header

Use hardwood screws and a screwdriver to affix the jambs to the header on both sides of the pocket door structure.

Step 7 - Meacertain the Solid Jambs

Measure the elevation of the solid side of the pocket door structure. Meacertain one side of the opening from the drywall edge to the oppowebsite edge of the drywall on the various other side of the opening.


Step 8 – Cut and Attach the Solid Jamb

Using the elevation measurement for the solid jamb cut the 1x4 inch board through the circular observed. Using the measurement of the opening; rip the cut board. Attach the solid jamb to the pocket door framework.

See more: Robr I Wanna Fly Can You Take Me Far Away 1 Hour Loop Wings, I Wanna Fly

Your pocket door is currently prepared to install the casing. You might want to glue the trim or use very short screws for this end up. You don’t want to scratch those new pocket doors. If you are installing the pocket doors on unfinimelted floors, you might uncover it important to usage a jamb witnessed to trim the bottom of the installed jambs prior to laying the flooring.